Maintenance of Bottle Blower

1. Feeding level without feeding: several situations need to be checked:
Has the hopper been unexpected? If yes, it needs to be fed as soon as possible.
No: Please check whether the control contactor of the elevator is in the state of power supply, if it is in the state of power supply, quickly check whether the motor is in the state of power supply and load, because this situation is likely to be blocked by the bottle blank (embryo), then the simple method is to help lift manually.
If the control contactor of the hoist is not in the power-on state, please check the bottle embryo to see if the electric eye is not in the same line as the reflector plate.
2. Feeding old clip feeding tray: This situation is a headache. Experience shows that if the length of bottle blank (embryo) is longer and the weight is larger, then this phenomenon is relatively small.
3 Bottles cannot be removed from the mould after blowing.
First of all, the mould should be opened and closed manually. If it is normal, run it in empty state, if it is normal.
Please check your exhaust time settings. If the exhaust settings are normal and every time a bottle is blown, it can be judged that the exhaust valve is a problem. Open the exhaust valve to check its spring and seal condition (another phenomenon of this failure is that the exhaust sound is relatively loud or the exhaust sound is not clear).
If you encounter a lot of mold production normally and occasionally come to this kind of die opening situation, please check whether the locking pin has a section of screw in it, and check whether the locking force is too large, if too large should be adjusted according to standard.
4 bottles are always pinched
Whether the position of the manipulator is misaligned or not.
5 Two manipulators collide
This situation requires manual reset of the manipulator, which is caused by dislocation.
Reproduced statement:
This article is reproduced on the Internet for the purpose of transmitting more information. It does not mean agreeing with its views or verifying the authenticity of its content. If the reprinted works infringe upon the author's signature rights, or other injuries such as copyright, portrait rights, intellectual property rights, etc., it is not intended by our website, it will be corrected immediately after receiving notification from the relevant obligee.